High quality fully sealed racing ignition harnesses for R35 cool conversion for the RB26 engine. Available for R32 GTR, R33 GTR and R34 GTR. 8 pin Deutsch connector also available as a special order item.
- German high quality tinned copper wires with FEP insulation (close in properties to PTFE but softer and UV resistant). 205°C. Unlimited continuous use under this temperature. Better properties than Tefzel (Mil-spec) ETFE wires which are older technology and good for up to 150-155°C continuous use. Also Tefzel is less flexible and has less bending endurance than FEP. So FEP wires are significantly more durable.
- KVT elastomer heat-shrinkable, flexible, chemical and abrasion resistant tubing as used in many racing harnesses. A slight improvement over widely used Raychem DR-25 with the same 150°C but with lower recovery temperature;
- Quality OEM connectors;
- Crimped tinned copper collets are used to connect wires, No solder used at all.
- Insulation of wires entering connectors (feature not met in competitor' harnesses).
**CAUTION** R35 Racing Spec Coil Harness
Coil harness connectors are a snug fit with the coils. Prior to shipping they are all tested end to end to ensure quality and connectivity.
When fitting ensure your push fit from the connector by pressing the button tab on the connector.
When removing the connector from the coils press the button tab and pull from the connector. Under no circumstances should you pull from the wire harness this may cause permanent damage to the coil harness.
Where a harness has been damaged due to negligence this will not be covered under our warranty.